Unminted US Half Dollar Coin Sphere Puzzle Coin Cutting Tracing

This Tools item by UnMintedLTD has 135 favorites from shoppers. Ships from United States. Listed on 10 Feb, 2024
*** Coins and Sharpie shown are not included *** The UnMinted Tracing Jigs are designed to make preparing your coin cuttings an easier start. The jig includes: - 3D Printed Tracing Jig for US Half Dollars - Instruction Sheet IMPORTANT: The jigs help you mark your cuts for using your jewelers saw. A quality jewelers saw and quality saw blades are recommended, as cheap blades will tend to wander while cutting. The coin spheres take time and practice to make, but are a great effect once your get the hang of it! Place the coin into the straight edge side pocket of the 3D printed jig to draw a quick center line (optional, but they are there if you want the alignment), then move the coin over to the main pocket to align and trace the shapes onto your coins. Please Note: For the Coin Sphere Puzzles, you'll need 3 coins, and each will have different cut-outs. I've designed these to work best with an Ultra Fine-Point Sharpie® held vertically when marking your cuttings - each of the slots are widened by ½ the diameter of the Sharpie®, so once marked, the goal is to cut as close to that outer edge of your markings as possible. Once cut, I use a mix of files / strips of sandpaper to clean up the edges and adjust as needed. For a snug fit when the coins are assembled, the width of the resulting slots should be close to the thickness of the coin you're working with. Ultra Fine-Point Sharpie® Recommended. ©2021 Copyright UnMinted Coin Co., LTD. All rights Reserved.

Tracing Jig Archives UnMinted Coin Co., LTD

USA Archives UnMinted Coin Co., LTD

OUR FAVOURITE BOOKS - All of our favourite classics. Free to read

US Currency Quarter (25 Cents) 15-Piece Coin Jigsaw Puzzle – RunIt

PDF) Assume the Positional: Comment on Robert Frank

Blog VitaDAO